Accord L4-2.4L (2005)
10. Remove the control arm mounting nut (A) and washer (B) from the knuckle.
11. Remove the trailing arm mounting bolt (A) from the knuckle
12. Remove the lower arm mounting bolt (A), and remove the knuckle (B).
13. Install the knuckle in the reverse order of removal, and note these items:
^
Be careful not to damage the ball joint boot when connecting the upper arm to the knuckle.
^
Use a new lower arm mounting nut and control arm mounting nut on reassembly.
^
Tighten the castle nut to the lower torque specification, then it only far enough to align the slot with the hole in the stud. Do not align the castle
nut by loosening it.
^
Tighten all mounting hardware to the specified torque values.
^
Before installing the wheel, clean the mating surface on the brake drum and the inside of the wheel.
^
Check the wheel alignment, and adjust it if necessary.
^
Fill the master cylinder reservoir to the MAX (upper) level line, and bleed the brake system. Check for a leak at the brake line to wheel
cylinder, and retighten if necessary.
