Accord L4-2156cc 2.2L SOHC (1991)
Programming the Transmitter
This transmitter is not programmable.
Ordering a Transmitter
This transmitter is no longer available.
Batteries for the Transmitter
The battery number is CR2025. Each transmitter uses two batteries.
97-99 EV Plus With Factory-Installed Security System
1997-99 EV Plus with factory-installed security system
Programming the Transmitter
NOTES:
^
The system accepts up to three transmitters. The transmitter codes are stored in a stacking-type memory. If a fourth transmitter code is
programmed, the code for the first transmitter is erased.
^
Entering the programming mode cancels all learned transmitter codes, so none of the previously programmed transmitters will work. You must
reprogram all of the transmitters once you are in the programming mode.
^
You must complete steps 1-6 within 4 seconds of the previous step to keep the system from exiting the programming mode.
1.
Turn the ignition switch to ON (II).
2.
Press the "Lock" or "Unlock" button on one of the transmitters. (An unprogrammed transmitter can be used for this step.)
3.
Turn the ignition switch to LOCK (0).
4.
Repeat steps 1, 2, and 3 two more times using the same transmitter used in step 2.
5.
Turn the ignition switch to ON (II).
6.
Press the "Lock" or "Unlock" button on the same transmitter. Make sure the power door locks cycle to confirm that the system is in programming
mode.
7.
Within 10 seconds, press the "Lock" or "Unlock" button on each transmitter. Make sure the power door locks cycle after you press each
transmitter button to confirm that the system accepted the transmitter's code.
5.
Turn the ignition switch to LOCK (0) to exit the programming mode.
Ordering a Transmitter
Transmitters can be ordered only through Tech Line.
Batteries for the Transmitter
The battery number is CR2025. Each transmitter uses one battery.
00-04 Insight With Factory-Installed Keyless Entry System
2000-04 Insight with factory-installed keyless entry system
