Accord L4-2156cc 2.2L SOHC (1991)
Driver's Side:
Remove the access panel from the steering wheel, then remove the short connector (RED) from the panel.
-
Disconnect the connector between the driver's airbag and cable reel, then install the short connector (RED) on the airbag side of the connector.
Front Passenger's Side (Sedan SE model):
-
Remove the glove box.
-
Disconnect the connector between the front passenger's airbag and SRS main harness, install the short connector (RED) on the airbag side of
the connector. Disconnecting the SRS Connector at the Fuse Box
CAUTION: Avoid breaking the connector; it's doublelocked
1
First lift the connector lid with a thin screwdriver, then press the connector tab down and pull the connector out.
2. To reinstall the connector, push it into position until it clicks, then close its lid.
-
Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.
-
Disconnecting the battery.
-
Removing the No.24 (7.5 A) fuse (in the under-hood fuse/relay box).
Removing the radio.
