Accord L4-2156cc 2.2L SOHC (1991)
9. Remove the 2 mounting bolts then remove the outside door handle. Pry the door handle latch rod out of its joint using a flat tip screwdriver.
NOTE:
-
When replacing the lock cylinder, pull out the retainer clip, take out the lock cylinder, then disconnect the lock rod.
-
To ease reassembly, note the location A of the rod on the joint before disconnecting it.
10. Remove the lower bolt of the center channel and slide the center channel toward the end of the door. Remove the screws and take the door
latch off the door, then push the door latch and rod inside the door.
NOTE: Take care not to bend the latch rods.
