honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Keyless Entry - Remote Transmitter Information|Page 8398 > < Keyless Entry - Remote Transmitter Information|Page 8396
Page 22
background image

Programming the Transmitter

NOTES:

^

The system accepts up to three transmitters. The transmitter codes are stored in a stacking-type memory. If a fourth transmitter code is
programmed, the code for the first transmitter is erased.

^

Entering the programming mode cancels all learned transmitter codes, so none of the previously programmed transmitters will work. You must
reprogram all of the transmitters once you are in the programming mode.

^

You must complete steps 1-6 within 4 seconds of the previous step to keep the system from exiting the programming mode.

1.

Turn the ignition switch to ON (II).

2.

Press the "Lock" or "Unlock" button on one of the transmitters. (An unprogrammed transmitter can be used for this step.)

3.

Turn the ignition switch to LOCK (0).

4.

Repeat steps 1 2, and 3 two more times using the same transmitter used in step 2.

5.

Turn the ignition switch to ON (II).

6.

Press the "Lock" or "Unlock" button on the same transmitter. Make sure the power door locks cycle to confirm that the system is in programming
mode.

7.

Within 10 seconds, press the "Lock" or "Unlock" button on each transmitter. Make sure the power door locks cycle after you press each
transmitter button to confirm that the system accepted the transmitter's code.

8.

Turn the ignition switch to LOCK (0) to exit the programming mode.

Ordering a Transmitter

Transmitters can be ordered only by authorized Honda dealers. Order them from American Honda using normal parts ordering procedures.

Batteries for the Transmitter

The battery number is CR2025. Each transmitter uses one battery.

94-95 Passport (Except 1995-1/2)

1994-95 Passport (except 19951A) with dealer-installed security system

NOTES:

^

The system uses a stacking-type memory that accepts up to four transmitters. If you program a fifth transmitter, the memory for the first
transmitter is pushed out, and it will no longer work.

^

To clear a lost or stolen transmitter from the system's memory, program a transmitter four times. This will remove the missing transmitter from
memory, since only four transmitters can be accepted.

Keyless Entry - Remote Transmitter Information|Page 8398 > < Keyless Entry - Remote Transmitter Information|Page 8396