Accord L4-2156cc 2.2L SOHC (1991)
Programming the Transmitter
1.
Locate the security system control unit under the driver's seat.
2.
Rub your finger over the label on the top of the control unit until you find the depression. Once you find it, push your finger through the label to
expose the hole underneath. Inside the hole is a square, yellow button; this is the programming button.
3.
Turn the ignition switch to ON, then turn it to LOCK.
4.
Press and hold the programming button. Check that the security siren emits four separate chirps followed by a five-chirp burst. This confirms that
the system is in programming mode. The siren then emits prompting chirps at 3-second intervals.
5.
Release the programming button.
6.
After a prompting chirp, press the "LOCK" button on the transmitter. Verify that the siren emits a confirmation chirp to confirm that the
transmitter's code was accepted by the control unit. If you wait more than 30 seconds after the prompting chirp before programming a transmitter,
or wait more than 30 seconds between programming transmitters, the siren emits three chirps and the system exits the programming mode.
7.
To program additional transmitters, wait for another prompting chirp, then press the "LOCK" button. (You can program up to four transmitters per
vehicle.)
8.
To exit the programming mode, turn the ignition switch to ON, then turn it to LOCK.
9.
Test all the transmitters.
Ordering a Transmitter
Transmitters can be ordered only by authorized Honda dealers. Order them from American Honda using normal parts ordering procedures.
Batteries for the Transmitter
The battery number is 23-144 (Radio Shack), A-23 (Eveready), or MS-21/MN-21 (Duracell). Each transmitter uses one battery.
