Accord L4-2156cc 2.2L SOHC (1991)
96-97 Passport With Dealer-Installed Security System
1996-97 Passport with dealer-installed security system
NOTES:
^
The system uses a stacking-type memory that accepts up to two transmitters. If you program a third transmitter, the memory for the first
transmitter is pushed out, and it will no longer work.
^
To clear a lost or stolen transmitter from the system's memory, program a transmitter two times. This will remove the missing transmitter from
memory, since only two transmitter codes can be accepted.
^
Another way to clear a lost or stolen transmitter is to erase all transmitter codes and then reprogram them. To do this, refer to the security system
owner's manual.
Programming the Transmitter
1.
Move the driver's seat forward. Locate the security system control unit mounted on the floor underneath the seat.
2.
Turn the ignition switch to ON.
3.
Use a pen or pencil to press and hold the green programming button on the side of the control unit. When the security system LED on the
instrument panel comes on, release the programming button. (Steps 3 and 4 must be done within 5 seconds of each other.)
4.
Press and release the top button on the transmitter. Verify that the LED goes out, the siren chirps once, and the front sidemarker lights flash to
confirm that the transmitter's code was accepted by the control unit.
5.
Turn the ignition switch to LOCK, then to ON.
