Accord L4-2156cc 2.2L SOHC (1991)
6.
Press and hold the green programming button on the side of the control unit until the LED on the instrument panel begins to flash, then release the
button. (Steps 6 and 7 must be done within 5 seconds of each other.)
7.
Press and release the bottom button on the transmitter. Verify that the LED goes out, the siren chirps twice, and the front sidemarker lights flash
twice to confirm that the transmitter's code was accepted by the control unit.
8.
Turn the ignition switch to LOCK. Test the transmitter you just programmed. If it doesn't work repeat steps 2 thru 7.
9.
If you have another transmitter to program, repeat steps 2 thru 7.
Ordering a Transmitter
Transmitters can be ordered only by authorized Honda dealers. Order them from American Honda using normal parts ordering procedures.
Batteries for the Transmitter
The battery number is CR2025. Each transmitter uses one battery.
98-02 Passport With Factory-Installed Security System
1998-02 Passport with factory-installed security system
Programming the Transmitter
To program the transmitters, use one of these two procedures:
^
Procedure One cancels all learned transmitter codes and adds one new transmitter. None of the previously programmed transmitters will work. Use
this programming procedure only if all transmitters were lost or stolen, or if a new control unit has been installed.
^
Procedure Two adds additional transmitters without cancelling any of the previously learned codes. The system will accept up to four transmitters.
Procedure One (cancels all codes, adds one new transmitter)
1.
Open the driver's door.
2.
Turn the ignition switch to the ACC position and then to the LOCK position three times. (This step must be completed within 10 seconds, or the
system will not enter the programming mode.)
3.
Within 10 seconds, close and open the door two times.
4.
Turn the ignition switch to the ACC position and then to the LOCK position five times. Close and open the door. (Complete this process within 10
seconds.) Verify that the power door locks cycle once to confirm that the system is in programming mode.
5.
Within 20 seconds, press the "LOCK" button on the transmitter you are programming. Verify that the door locks cycle once.
6.
Within 20 seconds, press the "UNLOCK" button on the transmitter. Verify that the door locks cycle once to confirm that the system has accepted
the transmitter's code.
Procedure Two (adds transmitters)
1.
Open the driver's door.
2.
Turn the ignition switch to the ACC position and then to the LOCK position three times. (This step must be completed within 10 seconds, or the
