Accord L4-2156cc 2.2L SOHC (1991)
Air Door Cable: Adjustments
Air Mix Cable
AIR MIX ROD AND CONTROL CABLE
1. Set the temperature control knob (lever) on COOL.
2. Turn the rod arm to the engine compartment side, then connect the rod to the clip.
4. Gently slide the cable outer housing back from the end enough to take up any slack in the cable, but not enough to make the temperature control
knob (lever) move, then snap the cable housing into the clamp.
5. After adjusting the air mix rod and cable, set the temperature control knob (lever) on HOT, blow warm air from the heater unit, then set it on
COOL and blow the cool air from it.
NOTE: The heater valve cable should always be adjusted whenever the air mix cable has been disconnected.