Accord L4-2156cc 2.2L SOHC (1991)
Evaporator Core: Service and Repair
Removal and Installation
CAUTION:
-
The Accord Wagon includes a driver's side airbag, located in the steering wheel hub, as part of a Supplemental Restraint System (SRS).
-
All SRS electrical wiring harnesses are covered with yellow outer insulation.
-
Before disconnecting the SRS wire harness, disconnect both battery cables and install the short connector on the airbag.
-
Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.
1. Disconnect the negative cable from the battery.
2. Use a Refrigerant Recovery/Recycling System to recover the refrigerant from the system.
3. Disconnect the receiver line and suction line from the evaporator.
CAUTION: Cap the open fittings immediately to keep moisture out of the system.
4. Remove the glove box and the glove box frame.
