Accord L4-2156cc 2.2L SOHC (1991)
Oil Filter: Service and Repair
WITHOUT NUMBERS ON THE FILTER
Oil Filter
WARNING: After the engine has been run, the exhaust pipe will be hot; be careful when working around the exhaust pipe. Be careful when
loosening the drain bolt while the engine is hot. Burns can result because the oil temperature is very high.
NOTE: Use only filters with a built-in bypass system.
1. Remove the oil filter with the special oil filter wrench.
2. Inspect the threads and rubber seal on the new filter. Wipe off seat on engine block, then apply a light coat of oil to the filter rubber seal.
Oil Filter Installation
3. Install the oil filter by hand.
4. After the rubber seal is seated, tighten the oil filter clockwise with the special tool.
5. Tighten: 7/8 turn clockwise.
6. Tightening torque: 16 ft-lb (22 Nm)