Accord L4-2156cc 2.2L SOHC (1991)
10.
Apply 3-M General Purpose adhesive Remover (P/N 051135-08984), or equivalent, to any double-sided tape left on the track. Follow the
precautions on the adhesive remover container. Let the remover soak in for about 10 minutes, then scrape the old tape off.
11.
Use a shop rag and more adhesive remover to wipe the track dry after you've scraped off the tape.
12.
Inspect the inside of the track from end to end for rubber debris. If necessary, remove the debris from the inside of the track and from both ends.
13.
Position the new seal on the track. The holes in the retractor end of an inner seal must fit over the two pins on the track.
14.
Then peel the paper off the adhesive backing and press the seal down as you go; don't pull the seal or stretch it. Make sure the rib on the back of
the seal fits into the groove in the track.
15.
Reinstall the clips in the locations you previously marked. Press each one onto the track as you pry up the inside edge with a screwdriver.
