Accord L4-2156cc 2.2L SOHC (1991)
36.
Reinstall the retractor assembly to the C-pillar. Torque the 6 mm bolt to 10 N-m (1.0 kg-m, 7 lb.ft.). Torque the 7/16 inch mounting bolt to 32 N-m
(3.2 kg-m, 23 lb.ft.).
37.
Pull the seat belt out slowly and verify that it does not lock. If the belt locks, replace the seat belt assembly.
38.
Repeat the appropriate interior removal steps and the sensor replacement steps on the other side.
39.
Reinstall the interior trim panels and seat.
^
Verify that all clips are connected to each trim piece before installing.
^
Make sure the quarter window trim on the 2-door is installed inside the rubber molding.
^
On the 2-door, pull the seat belts through the slots in the seat cushion as you are installing it.
40.
Center-punch a completion mark above the sixth digit of the engine compartment VIN.
PARTS INFORMATION
Seat Belt Retractor Sensor Kit:
P/N 06850-SM4-A00
H/C 4239968
WARRANTY CLAIM INFORMATION
Operation number:
865110
Flat rate time:
4-door
1.0 hour (both sides)
2-door
1.2 hours (both sides)
