Accord L4-2156cc 2.2L SOHC (1991)
Removing Tie Rod
9. Separate the tie-rod ball joint and knuckle using the special tool.
CAUTION: Avoid damaging the ball joint boot.
Gearbox Shield Removal
10. Remove the gearbox shield.
11. Using solvent and a brush, wash any oil and dirt off the valve body unit, its lines, and that end of the gearbox, blow them dry with compressed air.
Removing Lines From Valve Body
12. Using flare nut wrenches, disconnect the four lines from the control unit.
A: From pump: 14 mm wrench
B: To oil cooler: 12 mm wrench
C: To reservoir: 17 mm wrench
D: To power steering speed sensor: 12 mm wrench
13. Disconnect the 4P connector from the heated oxygen sensor. (EX, SE only)
