Accord L4-2156cc 2.2L SOHC (1991)
Pipe Bracket And HO2S Connector Installation
8. Install the pipe bracket.
9. Connect the 4P connector to the heated oxygen sensor. (EX, SE only)
Connect Tie Rod Ends
10. Reconnect the tie-rod ends to the steering knuckles, tighten the castle nut to the specified torque, and install new cotter pins.
CAUTION: Before tightening the steering joint bolts, pull up the steering joint to make sure that the steering joint is fully seated. Torque the castle nut
to the lower torque specification, then tighten it only far enough to align the slot with the pin hole. Do not align the nut by loosening.
Checking Cable Reel Centering
11. Center the steering rack with its strokes.
