Accord L4-2156cc 2.2L SOHC (1991)
2.
Roll the window all the way down. Insert the Sash Guide Adjuster (T/N 07MAG-SM2010A) in the lower half of the center sash guide slot; then hit
the tool with a ball peen hammer.
3.
Roll the window halfway up, and recheck the guide pin clearance by moving the window glass in and out.
4.
If the clearance is too tight and the window fails to close smoothly, carefully spread open the sheet metal of the center sash with a screwdriver.
Place a shop towel at the pry point to prevent scratches.
5.
Repeat steps 2 through 4, as needed, at several points along the center sash guide until the window does not move in and out.
6.
With the window halfway down, open and close the door several times. Listen for the window rattling.
^
If you do not hear the window rattling, the repair is complete.
^
If the window rattles, continue to step 7.
7.
Close the window. Remove the door panel (refer to service manual page 20-5).
