Accord V6-3.0L (2003)
16.
Apply Super High Temp Urea Grease to the short end of the center hook where it contacts the metal support on the basket flange, then install the
hook with its small end on the left side of the flange. If the yoke is not connected to the center hook, reconnect it.
17.
Install the cable into the basket, then route the cable behind the slide wire and the cross wire.
18.
Connect the Z cable end to the left side of the yoke bar.
19.
Install the small hook of the hanger wire into the yoke bar with the hook pointing toward the rear of the vehicle.
20.
Route the top of the hanger wire behind the slide wire and the cross wire. Pull down and flex the top of the basket. Install the top of the hanger
wire through the slot in the top of the basket, then move the wire to the right until the small end of the hanger hook is seated into the hole.
21.
Sit in the driver's seat, and check the lumbar support by cycling the adjustment from minimum to maximum several times.
