Accord V6-3.0L (2003)
12. Install the brake pads and pad shims correctly.
Install the brake pads with the wear indicator (C) on the inside. The wear indicator should be on the top of the pad.
If you are reusing the pads, always reinstall the brake pads in their original positions to prevent a momentary loss of braking efficiency.
13. Push in the piston (B) so the caliper will fit over the brake pads. Check the brake fluid level. The brake fluid may overflow if the reservoir is too
full. Make sure the piston boot is in position to prevent damaging it when pivoting the caliper down.
14. Pivot the caliper (C) down into position. Install the flange bolt (D), and tighten it to the specified torque while holding the pin A with a wrench
being careful not to damage the pin boot.
15. Install the brake hose mounting bolt (A), and tighten it to the specified torque.
16. Press the brake pedal several times to make sure the brakes work.
NOTE: Engagement of the brake may require a greater pedal stroke immediately after the brake pads have been replaced as a set. Several
