Accord V6-3.0L Hybrid (2005)
Driver/Vehicle Information Display: Testing and Inspection
Safety Indicator Input Test
Safety Indicator Input Test
1. Before testing the safety indicator functions, troubleshoot the multiplex integrated control system using the B-CAN System Diagnosis Test Mode
A.
Multiplex Integrated Control Unit
2. Remove the left kick panel.
3. Disconnect the under-dash fuse/relay box connectors E, H and P.
NOTE: All connectors are wire side of female terminals.
4. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, are recheck the system.
-
If the terminals look OK, go to step 5.
5. Reconnect the connectors to the under-dash fuse/relay box.
6. Turn the ignition switch to ON (II) to keep the system awake and make sure these input tests at the appropriate connectors on the under-dash
