Accord V6-3.0L Hybrid (2005)
26. Apply liquid gasket, P/N 08717-0004, 08718-0001, 08718-0003, or 08718-0009, evenly to the engine block mating surface of the engine block
end cover.
NOTE: Do not install the parts if 4 minutes or more have elapsed since applying the liquid gasket. Instead, reapply liquid gasket after removing
the old residue.
27. Install the dowel pins (A), new O-ring (B), and the engine block end cover (C) on the engine block.
28. Clean the excess grease off the crankshaft, and check the seal for distortion.
29. Install a new crankshaft oil seal in the oil pump.
30. Remove all of the old liquid gasket from the oil pump mating surfaces, bolts, and bolt holes.
31. Clean and dry the oil pump mating surfaces.
32. Apply liquid gasket, P/N 08717-0004, 08718-0001, 08718-0003, or 08718-0009, evenly to the engine block mating surface of the oil pump.
NOTE: Do not install the parts if 4 minutes or more have elapsed since applying the liquid gasket. Instead, reapply liquid gasket after removing
the old residue.
