Accord V6-3.0L Hybrid (2005)
3. When you're done torquing all the bolts, tighten them further in two steps (90 degrees per step) in sequence. If you're using a new bolt, tighten that
bolt an extra 90 degrees. If you tighten a bolt beyond the specified angle, remove that bolt and remeasure its diameter.
Replace the bolt if needed. Don't loosen it back to the specified angle.
IMPORTANT:
Make yourself a copy of this article, and keep it at your workstation. Not all S/Ms include this 12-point head bolt info yet. Those S/Ms will be
revised at a later time.