Accord V6-3.0L Hybrid (2005)
6. Tighten the four bolts (A) securing the transmission, then install the sealing bolts (B).
7. Install the rear warm up three way catalytic converter (rear WU-TWC) bracket.
8. If the engine is still in the vehicle, do the following steps.
9. Loosely install the four subframe mounting bolts and four 12 x 1.25 mm bolts with the stiffeners.
10. Loosely install both of the new mid-mounting bolts.
11. Align the reference marks with edge of both rear stiffener, and tighten the rear subframe mounting bolts, then front bolts, and tighten the stiffener
bolts to the specified torque.
12. Tighten the mid-mount mounting bolts.
13. Remove the jack and special tool.
14. Lower the vehicle on the hoist, then remove the engine hanger and engine balancer bar.
15. Raise the vehicle on the hoist to full height.
16. Tighten the bolt securing the transmission lower mount.
17. Lower the vehicle on the hoist.
18. Install the shift cable bracket, then install the harness clamp.
19. Tighten the rear mount bolt, then install the rear mount stop. Connect the rear active control engine mount actuator connector.
20. Tighten the front mount bolt, then install the front mount stop. Connect the front active control engine mount actuator connector, then install the
harness clamp.
21. Install exhaust pipe A, using new gaskets and new self locking nuts.
22. Raise the vehicle on the hoist to full height.
23. Connect the suspension lower arms to the knuckles.
24. Connect the tie-rod end ball joints to the knuckles.
25. Install the damper fork.
26. Connect the stabilizer links.
27. Install splash shield.
28. Install the front wheels.
29. Lower the vehicle on the hoist.
30. Install the connector bracket to the front cylinder head.
31. Install the harness clamp bracket to the rear cylinder head.
32. Align the reference mark on the steering joint and steering gearbox pinion shaft. Connect the steering joint to the steering gearbox pinion shaft.
Tighten the steering joint bolt. Install the steering joint cover.
33. Connect the connectors to the steering gearbox.
34. Install the intake manifold cover.
35. Install the front grille cover.
