Accord V6-3.0L Hybrid (2005)
Voltage Converter: Service and Repair
DC-DC Converter Removal/Installation
DC-DC Converter Removal/Installation
NOTE: Put on gloves to protect your hands from electrical shock. IMA components are located in this area. The IMA is a high-voltage system. You
must be familiar with the IMA system before working on or around it. Make sure you have read the IMA service precaution before doing repairs or
service.
1. Disconnect the negative cable from the 12 V battery.
2. Remove the IPU lid.
3. Remove the MCM.
4. Remove the junction board.
5. Remove the wires (A).
6. Remove the bolts (B), and DC-DC converter (C).
7. Install the parts in the reverse order of removal.
NOTE: If the IMA battery level gauge (BAT) displays no segments, start the engine, and hold it between 3,500 rpm and 4,000 rpm without load
(in Park or neutral) until the BAT displays at least three segments.
