Accord V6-3.0L Hybrid (2005)
Is there about 5 V?
YES - Replace the sensor that restored 5 V when disconnected.
NO - Go to step 54.
54. Turn the ignition switch OFF.
55. Jump the SCS line with the HDS.
56. Disconnect the connectors from these sensors:
-
Manifold absolute pressure (MAP) sensor
-
Output shaft (countershaft) speed sensor
57. Disconnect PCM connector A (31P).
58. Check for continuity between PCM connector terminal A12 and body ground.
Is there continuity?
YES - Repair short in the wire between the PCM (A12) and the MAP sensor or the output shaft (counter shaft) speed sensor.
NO - Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck. If the symptom/indication goes away
with a known-good PCM, replace the original PCM.
59. Measure voltage between body ground and PCM connector terminal C13.
Is there about 5 V?
YES - Go to step 67.
NO - Go to step 60.
60. Turn the ignition switch OFF.
