Accord V6-3.0L Hybrid (2005)
Engine Control Module: Service and Repair
Removal/Installation
How to Remove the PCM for Testing
If DTC troubleshooting requires voltage or resistance checks at the PCM connectors, remove the PCM and test it.
1. Jump the SCS line with the HDS.
2. Remove the center lower covers (A).
3. Remove the duct (B).
4. Disconnect the PCM connectors (C).
5. Remove the bolts (D), then remove the PCM (E).
6. Install the PCM in the reverse order of removal.
7. Open the SCS line with the HDS.
