Accord V6-3.0L Hybrid (2005)
^
Before you update the PCM, make sure the vehicle's battery is fully charged.
^
To prevent PCM damage, do not operate anything electrical (audio system, brakes, A/C, power windows, etc.) during the update.
^
During the update process, the HDS screen may turn off. This does not mean the update is complete. Tap the screen and the display will come on
showing the current condition of the update. Do not disconnect the HDS until the update is complete.
1.
If not already done, load the September 2005 or later software update onto the HDS.
2.
Connect the HDS to the DLC, and use the HDS to read, then clear the DTCs.
3.
Use the HDS to update the PCM. For updating instructions, refer to service bulletin 01-023, Updating Control Units/Modules. Verify that the
PGM-FI Program ID being used to update the PCM is the same or later than the Program ID listed in SOFTWARE INFORMATION.
Disclaimer
