Accord V6-3.0L Hybrid (2005)
If the wire tie is improperly attached, adjusting the seat could damage the seat position sensor harness.
12.
Reconnect the seat cushion cover to the cushion frame spring.
13.
Reconnect the floor harness connector.
14.
Reconnect the negative battery cable.
15.
Set the seat back on the floor, and loosely install the seat's two front mounting bolts. Tightening the bolts before installing the rear seat bolts may
misalign the seat tracks.
16.
Slide the seat forward, and install its two rear mounting bolts. Torque the bolts to 34 N.m (25 lb-ft).
17.
Install the rear track end covers.
18.
Slide the seat back, and torque its front mounting bolts to 34 N.m (25 lb-ft).
19.
Check the 8-way power seat operation.
20.
Enter the anti-theft codes for the audio and navigation system (if equipped), then enter the audio presets.
21.
Center-punch a completion mark above the seventh character of the engine compartment VIN.
