Accord V6-3.0L Hybrid (2005)
7.
To access the underside of the front seat, tilt the seat so the seat-back rests against the rear seat. It is not necessary to remove the seat from the
vehicle.
NOTE:
Make sure there is enough slack in the floor wire harness when tilting the seat. If there is not enough slack, disconnect the floor wire harness
connector.
8.
Unhook the seat cushion cover from the cushion frame spring.
9.
Remove the original seat position sensor harness:
^
Disconnect the black seat position sensor connector.
^
Remove the brown clip from the seat position sensor cover.
^
Cut and discard the wire tie.
^
Disconnect the gray connector, and remove the clip from the seat frame.
10.
Install the new seat position sensor harness:
^
Connect the black seat position sensor connector.
