Accord V6-3.0L Hybrid (2005)
Cruise Control Switch: Testing and Inspection
Cruise Control Combination Switch Test/Replacement
SRS components are located in this area. Review the SRS component locations, and the precautions and procedures, before performing repairs or
service.
1. Remove the driver's airbag.
2. Remove the four screws, then disconnect the connectors, and remove the switch.
3. Check for continuity between the terminals in each switch position according to the table.
-
If there is continuity, and it matches the table, but switch failure occurred on the cruise control unit input test, check and repair the wire harness
on the switch circuit.
-
If there is no continuity in one or more positions, replace the switch.
