Accord V6-3.0L Hybrid (2005)
Impact Sensor: Service and Repair
Front Impact Sensor Replacement
Front Impact Sensor Replacement
Removal
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Disconnect the driver's airbag 4P connector, the front passenger's airbag 4P connector, and both seat belt tensioner 4P connectors.
3. Remove the front bumper.
4. Remove the intake air resonator for the left side sensor.
5. Disconnect the engine compartment wire harness 2P connector (A), and using a Torx T30 bit, remove the two Torx bolts (B), then remove the
front impact sensor (C).
Installation
1. Install the new front impact sensor with Torx bolts (A), then connect the engine compartment wire harness 2P connector (B) to the front impact
sensor (C).
2. Reconnect the driver's airbag 4P connector, the front passenger's airbag 4P connector, and both seat belt tensioner 4P connectors.
3. Reconnect the battery negative cable.
4. After installing the front impact sensor, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for
about 6 seconds and then go off.
5. Install all removed parts.
