Accord V6-3.0L Hybrid (2005)
^
Attach the brown clip to the side of the seat position sensor cover.
^
Attach the gray connector and clip to the seat frame.
11.
Attach the new wire tie:
^
The wire tie must be placed around the white tape on the seat position sensor harness, the black tape on the SRS harness, and the correct seat
spring.
^
The correct seat spring is located behind the front crossmember bar and 240 mm from the outboard seat frame.
^
Fasten the wire tie to the straight section of the seat spring, not the curved part.
^
The wire tie should be snug. If the wire tie deforms the corrugated tubing, it is too tight. If you can slide a pencil in between the seat position
sensor, the SRS wires, and the wire tie, it is too loose.
NOTE:
