Accord V6-3.0L Hybrid (2005)
Pressure Regulating Solenoid: Service and Repair
A/T Clutch Pressure Control Solenoid Valve C Replacement
A/T Clutch Pressure Control Solenoid Valve C Replacement
1. Remove the intake air duct and air cleaner housing.
2. Disconnect the A/T clutch pressure control solenoid valve connector.
3. Remove the A/T clutch pressure control solenoid valve C.
4. Remove the ATF joint pipes, O-rings, ATF pipe, and gasket.
5. Clean the mounting surfaces and the fluid passages of the solenoid valve body and the transmission housing.
6. Install the 8 x 53 mm ATF joint pipe (A) with the filter side into its mounting hole (B).
7. Check the height (A) of the 8 x 53 mm ATF joint pipe (B) between the top (C) of the pipe and the solenoid valve body mounting surface (D). The
height is about 7 mm (0.3 inch). If the height is over 7 mm (0.3 inch), push the pipe until it bottoms in the accumulator body.
