Accord V6-3.0L Hybrid (2005)
2. Install the valves and springs in the sequence shown for the main valve body, secondary valve body, regulator valve body, and accumulator body.
Refer to the following valve cap illustrations, and install each valve cap so the end shown facing up will be facing the outside of the valve body,
then secure the valve cap with the valve cap clip.
3. Install the valve (A) and valve spring (B) in the valve body. Push the valve spring in with a screwdriver, then install the spring seat (C).
Main Valve Body Disassembly, Inspection, and Reassembly
1. Clean all parts thoroughly in solvent or carburetor cleaner, and dry them with compressed air. Blow out all passages.
2. Do not use a magnet to remove the cooler check valve, it may magnetize the check valve (ball).
3. Inspect the main valve body for scoring and damage.
4. Check all valves for free movement. If any fail to slide freely, refer to valve body repair.
5. Coat all parts with ATF during assembly.
