Accord V6-3.0L Hybrid (2005)
20. Bend the band end (A) by tapping it down with a hammer.
NOTE:
^
Make sure the band and clip do not interfere with anything on the vehicle and the band does not move.
^
Remove any grease remaining on the surrounding surfaces.
21. Repeat steps 13 through 20 for the band on the other end of the boot.
22. Install the new set ring.
Outboard Joint Side
1. Wrap the splines with vinyl tape (A) to prevent damage to the outboard boot.
2. Install the new ear clamp bands (B) and outboard boot, then remove the vinyl tape. Be careful not to damage the outboard boot.
