Accord V6-3.0L Hybrid (2005)
13. Apply primer to the edge of the rear window (A) where the molding adhesive tape will be attached as shown. Attach the molding (B) with adhesive
tape (C) to the lower edge of the rear window:
-
Be sure both ends of the molding line up with the alignment marks (D) of the rear window.
-
After installing the molding, cut the ends (E) of the molding as shown.
-
Be careful not to touch the windshield where adhesive will be applied.
14. Attach the fasteners (A) with adhesive tape to the rear window opening flange (B) of the body on both sides.
15. Set the rear window in the opening, and center it. Make alignment marks (A) across the rear window and body with a grease pencil at the four
points shown. Make sure both upper clips (B) are in the body holes. Be careful not to touch the rear window where adhesive will be applied.
16. Remove the rear window.
