Accord V6-3.5L (2010)
1. Using a # 0 Phillips screwdriver, remove the screw from the transmitter. Remove the back cover, then use a small piece of tape to hold the module
temporarily in place during the programming steps.
2. Connect the HDS to the DLC (data link connector).
3. Insert the customer's programmed ignition key into the ignition switch, and turn the ignition switch to ON (II). Turn on the HDS.
4. At the screen prompts, enter the VIN and the odometer reading, then verify the correct date and time.
5. From the System Selection Menu screen, select IMMOBI.
6. From the Immobilizer Test Mode Menu screen, select Immobilizer Setup.
7. From the Immobilizer Test Mode Menu screen, select Add and Delete Keys.
8. From the Add and Delete Keys screen, select Add 1 Key.
9. From the Add 1 Key screen, select Begin to Add 1 Key.
