Accord V6-3.5L (2010)
Seat Cover: Service and Repair
Front Seat-back Cover Replacement (4-Door)
Front Seat-back Cover Replacement
Special Tools Required
-
KTC Trim Tool Set SOJATP2014
-
Trim Pad Remover Snap-on A 177A or equivalent, commercially available
*
4-door
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations/SRS Component
Location Index (4-Door) and the precautions and procedures See: Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and
Disarming/Service and Repair before doing repairs or service.
Do the OPDS sensor initialization See: Restraint Systems/Air Bag Systems/Testing and Inspection/Programming and Relearning/ODS Unit Initialization,
after front passenger's seat-back cover replacement.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to tear or damage the seat covers.
-
Passenger's seat: Do not touch the OPDS sensor in the seat-back cover/pad, and keep it away from oil. Oil can corrode the sensor causing it to fail.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Driver's seat is shown; passenger's seat is similar.
1. Remove the front seat See: Service and Repair/Front Seat Removal/Installation.
2. With back panel: From under the seat cushion, release the elastic strap (A) from the seat cushion frame springs (B), then pull back the under cover
(C) of the back cover.
3. Insert a trim pad remover between the bottom of the back panel (A) and the seat frame until it squarely engages one of the clips. Gently pry on the
clip until it detaches from the seat frame. Repeat for the other clip. Gently pull back the back panel to release the hooks (B), then pull down the
panel to release the hooks (C).
NOTE:
