Accord V6-3.5L (2010)
22. Tighten the bolt until the mark on the bolt head lines up with the mark on the connecting rod (turn the bolt 90 °).
NOTE: Remove the connecting rod bolt if you tightened it beyond the specified angle, and go back to step 16 of the procedure. Do not loosen it back to
the specified angle. Repeat steps 10 to 22 for the remaining cylinders.
23. Tighten the bearing cap bolts and the bearing cap side bolts to the specified torque in the sequence as shown. Repeat the torque sequence again to
ensure the bolts are properly torqued.
