Accord V6-3.5L (2010)
Camshaft Oil Seal: Service and Repair
Camshaft Oil Seal Installation - In Car (J35Z3 Engine)
Camshaft Oil Seal Installation - In Car
Special Tools Required
-
Ball Joint Remover/Installer 07GAF-SD40330
1. Remove the timing belt See: Timing Components/Timing Belt/Service and Repair/Timing Belt Removal (J35Z3 Engine).
2. Remove the camshaft pulley and the back cover See: Cylinder Head Assembly/Service and Repair/Removal and Replacement/Cylinder Head
Removal (J35Z3 Engine).
3. Remove the camshaft oil seal.
4. Clean and dry the camshaft oil seal housing.
5. Apply a light coat of new engine oil to the lip of the camshaft oil seal.
6. Using the ball joint remover/installer (A), a washer (B), and a 12 x 75 x 1.25 mm bolt (C), press in the new camshaft oil seal (D) about 0.5-1.5 mm
(0.02-0.06 in) below the surface of the cylinder head.
7. Apply new engine oil to the threads of the camshaft pulley mounting bolt. Install the back cover, then install the camshaft pulley.
-
Front See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Camshaft, Rocker Arm Assembly, Camshaft Seal, and Pulley
Installation (J35Z3 Engine)
-
Rear See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Camshaft, Rocker Arm Assembly, Camshaft Seal, and Pulley
Installation (J35Z3 Engine)
8. Install the timing belt See: Timing Components/Timing Belt/Service and Repair/Timing Belt Installation (J35Z3 Engine).
