Accord V6-3.5L (2010)
9. Remove the spring clip (B) and the control pin (C), then separate the shift cable end (D) from the selector control lever (E).
10. Check the bushing (F) in the shift cable end for proper fit and wear. If the bushing is loose or worn, replace the shift cable See: Automatic
Transmission/Transaxle/Shift Linkage/Shift Cable/Service and Repair.
11. Disconnect the A/T clutch pressure control solenoid valve A connector (A), the A/T clutch pressure control solenoid valve B connector (B), the
4th clutch transmission fluid pressure switch connector (C), shift solenoid wire harness connector (D), and the input shaft (mainshaft) speed sensor
connector (E).
