Accord V6-3.5L (2010)
22. Install new O-rings (two O-rings per shift solenoid valve) (E) on the reused shift solenoid valves.
NOTE: A new shift solenoid valve comes with new O-rings. If you install a new solenoid valve, use the O-rings provided with it.
23. If shift solenoid valve D was replaced, install shift solenoid valve D (black connector) by holding the shift solenoid valve body; make sure the
mounting bracket contacts the accumulator body.
NOTE: Do not hold the solenoid valve by the connector when installing the solenoid valve. Be sure to hold the solenoid valve body.
24. If shift solenoid valve A was replaced, install shift solenoid valve A (black connector) by holding the shift solenoid valve body; make sure the
mounting bracket contacts the accumulator body.
25. If shift solenoid valve C was replaced, install shift solenoid valve C (brown connector) by holding the shift solenoid valve body; make sure the
mounting bracket contacts the bracket of shift solenoid valve A.
NOTE: Do not install shift solenoid valve C before installing shift solenoid valve A. If shift solenoid valve C is installed before installing shift solenoid
valve A, it may damage the hydraulic control system.
26. If shift solenoid valve B was replaced, install shift solenoid valve B (brown connector) by holding the shift solenoid valve body; make sure the
mounting bracket contacts the accumulator body.
27. Install the shift solenoid valve mounting bolts.
28. Connect the shift solenoid valve connectors to the shift solenoid valves:
-
YEL wire connector to shift solenoid valve A.
-
RED wire connector to shift solenoid valve B.
-
GRN wire connector to shift solenoid valve C.
-
ORN wire connector to shift solenoid valve D.
29. Install the shift solenoid valve cover, the dowel pins, and a new gasket.
30. Install a new gasket on the solenoid valve cover, and install the ATF pipes with their filter side into the transmission housing. Install new O-rings
over the ATF pipes.
31. Install A/T clutch pressure control solenoid valves A and B.
