Accord Coupe L4-2.2L SOHC (16 Valve) (1996)
/Page-1331002.png)
4. Mark the rollers and spider to identify the locations of rollers on the spider, then remove the rollers.
5. Remove the circlip.
6. Mark the spider and driveshaft to identify the position of the spider on the shaft.
7. Remove the spider using a commercially-available bearing remover.
8. Remove the stop ring.
9. Wrap the splines on the driveshaft with vinyl tape to prevent damage to the boots and dynamic damper.
10. Remove the boot band and inboard boot.
CAUTION: Take care not to damage the boot.
11. Remove the dynamic damper band and dynamic damper if equipped.
CAUTION: Take care not to damage the dynamic damper.
12. Remove the boot bands and outboard boot, then remove the vinyl tape.
CAUTION: Take care not to damage the boot.
