Accord Coupe L4-2.2L SOHC (16 Valve) (1996)
Transmission Mode Indicator - A/T: Adjustments
GEAR POSITION INDICATOR PANEL ADJUSTMENT
CAUTION:
-
All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag
connectors.
-
Whenever the ignition switch ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the
airbags could accidentally deploy and cause damage or injuries.
1. With the transmission in N position, check that the index mark on the indicator aligns with the N mark on the A/T gear position indicator panel
when the transmission is in N position.
2. If not aligned, remove the front console.
3. Remove the A/T gear position indicator panel mounting screws, and adjust by moving the panel.
NOTE: Whenever the A/T gear position indicator panel is removed, check the panel adjustment as described above.