Accord Coupe L4-2.2L SOHC VTEC (1995)
4. Remove the brake hose mounting bolts.
5. Remove the caliper bracket mounting bolts, and hang the caliper to one side.
CAUTION:To prevent accidental damage to the caliper or brake hose, use a short piece of wire to hang the caliper from the undercarriage.
6. On ABS equipped vehicles, remove the wheel sensor wire bracket, then remove the wheel sensor from the knuckle but do not disconnect the wheel
sensor connector.
NOTE:Use ball joint removers to separate the ball joints from the suspension or tie-rod end.
7. Clean any dirt or grease off the ball joint. Remove the cotter pin from the tie-rod end ball joint castle nut and remove the nut.
8. Apply grease to the special tool on the areas shown. This will ease installation of the tool and prevent damage to the pressure bolt threads.
9. Install a 10mm hex nut on the ball joint. Be sure that the hex nut is flush with the ball joint pin end to prevent damage to the threaded end of the
ball joint.
