Accord Coupe L4-2.2L SOHC VTEC (1995)
NOTE:
-
Be careful not to damage the pulley and compressor during removal/installation.
-
Once the snap ring is removed, replace it with a new one.
4. Remove the pulley from the shaft with a puller.
NOTE: Put the claws of the puller on the back of the pulley, not on the belt area; otherwise the pulley can be damaged. If the pulley doesn't come
off easily, replace the compressor, clutch set and field coil as a whole.
5. Remove the two bolts and the field coil.
-
Install the field coil with the wire side facing down as shown.
6. Clean the pulley and compressor sliding surfaces with non-petroleum solvent.
7. Position the pulley squarely over the field coil. Press the pulley onto the compressor boss with the special tool. If the pulley does not press on
straight, remove it, and check the pulley and compressor boss for burrs or damage.
