Accord Coupe L4-2.2L SOHC VTEC (1995)
Driver's Side:
-
Remove the short connector (RED) from the driver's airbag connector, then connect the airbag 3-P connector to the cable reel 3-P connector.
-
Attach the short connector (RED) to the access panel, then reinstall the panel on the steering wheel.
Front Passenger's Side:
-
Attach the SRS main harness 3-P connector to the connector holder.
-
Then reinstall the glove box on the dashboard.
6. Connect the battery positive cable, then connect the negative cable.
7. After installing the airbag assembly, confirm proper system operation:
-
Turn the ignition ON (II): The instrument panel SRS indicator light should come on for about six seconds and then go off.
-
Make sure both horn buttons work.
-
Take a test drive, and make sure the cruise control switches work.
8. Enter the code number to restore radio operation.
CAUTION:
-
Store a removed airbag assembly with the pad surface up If the airbag is improperly stored face down, accidental deployment could
propel the unit with enough force to cause serious injury.
-
Carefully inspect the airbag assembly before installing it. Do not install an airbag assembly that shows signs of being dropped or
improperly handled, such as dents, cracks or deformation.
-
Always keep the short connectors on the airbag connectors when the harness is disconnected.
-
Do not disassemble or tamper with the airbag assembly.
NOTE: The original radio has a coded theft protection circuit. Be sure to get the customer's code number before disconnecting the battery cables.
