Accord Coupe L4-2.2L SOHC VTEC (1995)
4. Measure the rivet depth from the lining surface to the rivets, on both sides.
-
Standard (New): 1.3 - 1.9 mm (0.05 - 0.07 inch)
-
Service Limit: 0.2 mm (0.01 inch)
NOTE: If the rivet depth is less than the service limit, replace the clutch disc.
INSTALLATION
1. Install the ring gear holder.
2. Apply grease to the splines of the clutch disc, then install the clutch disc using the special tools as shown.
NOTE: Use only Super High Temp Urea Grease (P/N 08798 - 9002).
