Accord DX Sedan L4-2254cc 2.3L SOHC MFI (2001)
15. Tighten the 11 mm bolts in two steps. In the first step, tighten all bolts in sequence to about 29 Nm (3.0 kgf-m, 22 ft. lbs.): in the final step,
tighten in the same sequence to 78 Nm (8.0 kgf-m, 58 ft. lbs.).
16. Tighten the 6 mm bolts in sequence to 12 Nm (1.2 kgf-m, 8.7 ft. lbs.).
NOTE: Whenever any crankshaft or connecting rod bearing is replaced, it is necessary after reassembly to run the engine at idling speed until it
reaches normal operating temperature, then continue to run it for approximately 15 minutes.
17. Drive the crankshaft oil seal squarely into the right side cover.
