Accord EX Coupe L4-2254cc 2.3L SOHC (VTEC) MFI (1998)
_mfi/Page-2414004.png)
SRS Main Harness 18P Connector (Wire Side Of Female Terminals)
16. Connect a voltmeter between the No.7 terminal of the SRS main harness 18P connector and ground.
17. Turn the ignition switch ON (II), and measure voltage.
Is there battery voltage?
YES - Poor contact at the SRS main harness 18P connector; check the connector. If the connector is OK, substitute a known-good SRS unit, and
recheck. If the connector is damaged, replace the SRS main harness.
NO - Go to step 18.
18. Turn the ignition switch OFF.
19. Disconnect the SRS main harness 2P connector (A) from the driver's under-dash fuse/relay box (B).
20. Check resistance between the No.1 terminal of the SRS main harness 2P connector and No.7 terminal of the SRS main harness 1 8P connector.
There should be 0 - 1.0 ohm.
Is the resistance as specified?
YES - Poor contact at the SRS main harness 2P connector; check the connector. If the connector is OK, substitute a known-good under-dash
fuse/relay box, and recheck. If the connector is damaged, replace the SRS main harness.
NO - Open in the SRS main harness, replace the SRS main harness.
