Accord EX Coupe L4-2254cc 2.3L SOHC (VTEC) MFI (1998)
_mfi/Page-2177006.png)
14. Wipe off any grease contamination from the ball joint tapered section and threads then reconnect tie-rod ends (A) to the steering knuckles. Install
the 10 mm nut (B) and tighten it.
15. Install the new cotter pin (C) and bend it.
16. Connect the M/T shift linkage or A/T shift cable from the transmission.
17. Install the three way catalytic converter.
18. Install the front wheels.
19. Fill the system with power steering fluid, and bleed air from the system.
20. After installation, perform the following checks.
-
Start the engine, allow it to idle, and turn the steering wheel from lock-to-lock several times to warm up the fluid. Check the gearbox for leaks.
-
Adjust the front toe.
-
Check the steering wheel spoke angle. Adjust by turning the right and left tie-rods equally, if necessary.
